INSTRUCTIONS

Parts included: 2 x Plates with Letters punched in them, 1 x Promoter packet

1. Wash the valve covers where your engine letters are with soap and water. Let dry, then rewash with thinner to remove any oils. This is important because the stainless steel letters will not bond properly to oily surfaces.
2. Remove one metal letter plate from the plastic. Push out the letters—they should come out easily. Use a tiny file to remove any burrs if necessary, being careful not to scratch the surface of the plate.
3. Without removing the backing liner, hold the letter plate over the engine letters and set it down into position. The engine letters should pop through the holes in the metal plate. This trial run helps you become familiar with how the plate will fit. You may need to very slightly bend the plate to fit flush with the valve cover surface.
4. Take the promoter packet. If it is a packet, rip it open to expose the moistened wipe inside. If it is a pen, snap it in the center and press down firmly several times until the pen tip is moist. Wipe the promoter over the surface where the plate will adhere.
5. Peel the backing off the back of the metal letter plate. It is now ready to stick.
6. Carefully hold the letter plate in position over the engine letters. Slowly guide it down until all the engine letters have popped through the holes.
7. Press down firmly over the entire surface of the letter plate and let it set for 12 hours.
8. Repeat this process with the reverse side letter plate.