PARTS INCLUDED:

1 x Driver Side Turn Signal

1 x Passenger Side Turn Signal

2 x Wire Harnesses with Bulbs

4 x 3/8″ x 1″ Bolts

4 x Fender Washers

4 x Locking Nuts

This kit is designed to be used as a replacement turn signal housing when removing the factory front bumper.

PROTECTIVE LINER INFORMATION: Your new accessories include a protective surface liner. Leave this liner in place until installation is complete to prevent fingerprints and possible scratches.

1. Place the turn signal fairing into the opening created after removing the front bumper. Be careful not to let the stainless edges damage your paint. Take a few minutes to inspect the fitment and make any hand adjustments at the rear corner so the curve matches the opening’s shape. Also, note the fairing’s position on the main frame to see if any adjustment is needed on the main fairing mounting tab. This tab contains two large holes, which allow you to position the fairing at the correct angle and alignment.
2. Once you understand how the fairing should sit, begin the installation. Peel back the liner just enough to place the unit without trapping it inside the car. Connect the harness quick-connect plug to the vehicle’s connector to complete the circuit. With the help of a friend, hold the unit in the correct position while your helper installs the two bolts with large washers and tightens them securely. The washer goes on the front side over the large tab holes to hold the unit firmly in place.
3. Remove the remaining protective liner to complete the installation. Repeat the same process on the opposite side.