Description
New Brushed Finish!
This piece really stands out.
This trim ring is a peel-and-stick brushed stainless steel finish piece. It fits right along the inner edge of your rear-view mirror.
Made of pure bright, shiny, heavy-gauge stainless steel with a brushed finish. It will not fade, stain, or rust.
Everything you need is included. Easy to install – just peel and stick.
INSTALLATION INSTRUCTIONS
Parts included: Prowler rear-view mirror trim frame
- Begin by washing your rear-view mirror with a good glass cleaner. Be sure to clean the outer edges of the glass, as this is where you will attach the frame.
- Hold the trim frame up to the rear-view mirror and position it so that the entire trim ring lies on the mirror glass. You may need to gently and slightly bend the trim frame to fit your mirror. This piece is designed for the Prowler original stock mirror. If you have an aftermarket mirror, it may not fit.
- Remove the red backing from the trim frame. Place it on the glass along the outside perimeter, just as you did during the trial run.
Warning: The back of this trim frame uses permanent adhesive tape. You will not be able to reposition it once applied. Make sure it is perfectly aligned. Press down gently at first (you may be able to adjust it slightly), then press firmly over the entire frame. If necessary, use masking tape around the edges to hold it in place. Allow it to bond for 8 hours.
Immediately wipe away any excess promoter using a small patch of rubbing alcohol. - After the drying period, remove the masking tape. Clean the stainless steel trim frame again with rubbing alcohol to remove any residue.




































