Description
Car Show Quality Part.
Large, high-quality, all stainless-steel radiator support cover with a high-polished finish for a chrome-like look. This piece will transform your Prowler’s engine bay into a true show car display.
No drilling required — uses existing bolts. Will not rust, corrode, or lose its luster.
INSTALLATION INSTRUCTIONS
PARTS INCLUDED:
- 1 x Stainless Radiator Cover
- 2 x 1/8″ Washers
- 2 x Stainless 6MM Bolts
- 2 x Flat Washers
- 4 x Decorative Chrome Caps
Your new cover comes with a protective liner. Do not remove the liner until instructed to do so.
This unique cover allows you to customize an area of your Prowler that has never before been available. Follow these steps for installation:
- Remove the two main bolts securing the engine bay support bars to the factory radiator support, then slide the bars to the sides. NOTE: These two bolts will be replaced.
- Place the two 1/8″ thick washers over the bolt holes. Place the new cover over the factory radiator support and allow the two outer factory nuts to protrude through the holes in the cover. Remove the protective liner.
- Slide the support bars back into position and secure them in place with the two stainless 6MM bolts and flat washers provided.
- Press the four decorative chrome caps into place over each nut and bolt location.

























