Description
Real pure, high-quality stainless steel — high polished and precision laser cut — to fit perfectly into the indented letters on your rear bumper. These bright, shiny pieces really pop out and transform the look of your Prowler!
They will not rust, corrode, or stain, and will maintain their mirror-like luster for the life of your car.
Each letter is pre-mounted with professional-grade 3M automotive adhesive tape, precisely cut for a perfect fit. A pen-type liquid promoter is included to ensure a strong, lasting bond.
Available Options:
- Prowler Letters: Includes one set spelling “PROWLER”
- Plymouth Letters: Includes one set spelling “PLYMOUTH”
- Plymouth + Prowler Combo: Includes both letter sets
Compatibility: Fits all Plymouth Prowlers from 1997–2002.
Note: Letters are not sold individually. When applied properly, they will not come off — even on rough roads, through vibration, or potholes.
INSTRUCTIONS
Parts Included: 1 set of letters spelling “PROWLER” and/or 1 set of letters spelling “PLYMOUTH”
WARNING: It is very important to follow every step without skipping anything. This will ensure that you mount your insert letters professionally.
- Prepare the bumper indented letters by washing them thoroughly with soap and water. Let dry. Next, wash them with rubbing alcohol to remove any oily residues. NOTE: If you have used a protectant such as wax or Armor-All, you will need a more thorough cleaning process. Use a solvent such as thinner inside the indented letters to remove residue. Next: Use a small piece of sandpaper to scuff up the inside of the letters on your bumper. This will enable a strong bond with the trim letters.
- Once your indented letters are dry, begin forming the letters one at a time. NOTE: Do not remove the backing of the letters until instructed to do so. To hand-bend each letter, take the first letter and set it into its corresponding indented letter on the bumper (for example, start with the “P” in “Prowler”). Examine how it fits. Carefully bend the letter by hand to match the curve of your bumper. This is a process of trial and error. When finished, each letter should lie on and conform to the bumper exactly. NOTE: The short letters may not require any bending.
- Take out your promoter pen. Snap it sharply in the middle to break the glass ampoule inside. Press the promoter pen inside the indented letters on your bumper, covering them completely with the clear promoter liquid. Do this for every letter where you plan to mount the new inserts.
- Once you are satisfied with the fit, remove the backing of the first letter and press it firmly into the indented letters on your bumper.
- Repeat this process for each letter. It is important to get a precise fit because the automotive tape will not hold over the long run unless the letters are bent to the contour of the bumper. You may want to tape each mounted letter with masking tape to hold it in place for 12 hours. Once you remove the tape, clean the letters and bumper with a good glass cleaner.
