Description
Plymouth Prowler Third Brake Light Bezel in polished stainless steel. Easy peel-and-stick installation. Really dresses up the back end of your Prowler. Will not rust or corrode.
INSTALLATION INSTRUCTIONS
Included: 1 x 3rd Brake Light Bezel Trim, 1 x Promoter Pen
- Take your bezel out of the wrapper. Do not remove the red tape backing.
- Wash your 3rd brake light with soap and water, then wipe with rubbing alcohol. Rinse thoroughly and dry.
- Take your new bezel trim and hold it up against your 3rd brake light. Position it as you want to permanently mount it. Slightly hand-bend the ends to match the slight curve of your car’s lens assembly. You can do this by trial and error. Once the trim piece follows the curve of your brake light exactly and you are satisfied with the fit, move to the next step.
- Take your promoter pen and wipe the perimeter of your 3rd brake light where the trim bezel will stick. Let dry for one minute.
- Remove the red backing from the trim piece to expose the adhesive. Carefully position the trim bezel in place without touching it to the 3rd brake light. Once you are certain about the placement, lightly set it on the brake light lens. Make any final adjustments, then press on the bezel to secure it. With your fingers, press firmly all the way around the bezel to ensure it sticks on all sides.
- You may also use masking tape over the bezel to hold it tightly against the 3rd brake light overnight. The next morning, remove the masking tape and clean the area with rubbing alcohol. Finally, remove the plastic wrap from the outside of the trim piece. You’re done!











