Description
It will never rust and will always keep its luster!
Only available at TheProwlerStore.com
This beautiful stainless steel 3D emblem is made from two separate pieces of stainless steel. The Kat logo is cut out and recessed in both emblems, while the trim around them is raised. It adds stunning character to your new retro-style grille. You may mount it anywhere you like on the grille. Fits on either of our grilles.
INSTALLATION INSTRUCTIONS
Parts Included: 1 × Logo with self-adhesive back, 1 × Adhesive Promoter Packet.
- IMPORTANT: Clean the grille in the area you will mount the logo with soap and water to remove any dirt. Then clean again with household isopropyl alcohol or rubbing alcohol. You must remove even the slightest dirt and especially any oil (even from your fingers) from the grille surface. Let it dry for 3 minutes.
- Take the logo and, without removing the backing, position it against the grille to decide where you want to mount it. Bend the emblem gently so it follows the contour of the grille without forcing it down.
- Peel off the red backing from the logo to expose the adhesive. Avoid touching the adhesive surface.
Once you are satisfied with the placement, press firmly to set the emblem in place. Push along the entire perimeter edge to ensure a tight bond. Let it sit for 8 hours and avoid getting it wet during this time.
CARE AND MAINTENANCE: Lightly dust the emblem with a clean, soft cloth first to prevent scratches. Then wipe with a clean, soft cloth and a quality streak-free glass cleaner.








