INSTALLATION INSTRUCTIONS

Parts included:

• 2 x Headlight Lens Film Guards
• 1 x Small Felt Squeegee

For installation, you will need: Household rubbing alcohol, and a soapy water mixture (one full spray bottle of water with a couple of drops of baby shampoo or mild dish detergent).

WARNING: It is very important to follow every step without skipping anything. This ensures that your lens guards are mounted professionally.

1. Prepare both headlight lenses by washing them with soap and water to remove dirt and grime. Dry completely and wipe the lenses with household rubbing alcohol.
2. Place your unpeeled headlight guard over the lens to check the fit. Once you understand how it sits, remove the guard and spray your soapy water mixture directly on the headlight lens and on the lens guard, soaking it thoroughly as you peel the release liner. Once both the headlight lens and lens guard are completely saturated, place the guard on the lens and position it into place.
3. Use the provided soft, felt-tipped squeegee. Starting at the center of the lens, work the fluid out in all directions until the lens guard is fully adhered. A household hair dryer may help if any areas are stubborn.
4. Repeat the entire process for the opposite side.
5. Repeat the same process for the fog lights.