INSTALLATION INSTRUCTIONS

Parts included (based on a two-set or four-set):

• 2 x Polished Trim Wing Bezels
• 1 x Adhesive Promoter Packet

1. Clean the area around the side marker lights with soap and water to remove dirt, then wipe again with household isopropyl alcohol or rubbing alcohol. Let dry completely.
2. Without removing the backing from the new parts, hold each Light Trim Bezel up to its corresponding side marker light. Line it up with the light lens, ensuring the wings are straight and parallel to the ground. Position it so you are satisfied with how it will mount.
3. Open the promoter packet or pen and dampen the area around the light lens where the trim bezel will attach. This ensures the tape adheres firmly.
4. Once satisfied with the fit, peel the backing off the first Light Trim Wing Bezel. Position it slightly over the top of the light lens without touching the lens, then carefully set the trim bezel in place as you did during your practice run.
   NOTE: It is difficult to reposition the trim bezel once attached. Be sure to place it correctly the first time.
   NOTE: Each Light Trim Wing Bezel is designed for a specific side of the car, with the wings pointing toward the rear of the vehicle.
5. Once mounted, press the Light Trim Wing Bezel firmly over the entire surface, from top to bottom and left to right. Repeat for the other side bezel. Allow to set overnight.

Clean using a clean, soft cloth and good-quality glass cleaner.