INSTRUCTIONS

Parts included: 2 x Plates with Letters punched in them, 1 x Promoter packet

1. Wash the valve covers where your engine letters are with soap and water. Let dry, then rewash with thinner to remove any oils. This is important because the stainless steel letters will not bond properly to oily surfaces.
2. Remove one metal letter plate from the plastic. Push out the letters—they should come out easily. Use a tiny file to remove any burrs if necessary, being careful not to scratch the letters.
3. Without removing the backing liner, hold each letter over the engine letters and position it on top. Ensure the engine letters are centered in all directions. This trial run helps you become familiar with the fit. You may need to very slightly bend letters to fit flush with the valve cover surface.
4. Take the promoter packet. If it is a packet, rip it open to expose the moistened wipe inside. If it is a pen, snap it in the center and press down firmly several times until the tip is moist. Wipe the promoter over the top surface of each engine letter.
5. Peel the backing off the first letter. It is now ready to stick.
6. Carefully hold the letter in position over your engine letters. Slowly guide it down until it is evenly centered from top to bottom and side to side.
7. Press down firmly over the entire surface of the letter and let it set for 12 hours.
8. Repeat this process with the remaining letters.