Parts Included:

• 1 x Driver Side Turn Signal Fairing
• 1 x Passenger Side Turn Signal Fairing
• 2 x Wire Harnesses with bulbs
• 4 x 3/8″ x 1″ Bolts
• 4 x Fender Washers 3/8″ x 1.5″
• 4 x Lock Washers
• 4 x 3/8″ Nuts
• 2 x Optional Trim Rings

This kit is designed to be used as a replacement turn signal housing after removing the factory front bumper (plug and play).

1. Place the turn signal fairing into the opening created after the front bumper has been removed. Be careful not to damage your paint. Take a few minutes to inspect the fitment and make any adjustments at the rear corner so the curve matches the opening’s shape. Also note the position of the fairing at the main frame to determine if the main fairing mounting tab needs adjustment. This tab contains two large holes, which allow you to position the fairing at the correct angle and location.
2. Once you understand the correct positioning, proceed with installation. Your kit includes a replacement factory wire harness for the signal light. Connect the harness quick-connect plug to the vehicle’s receiving end. With help from a friend, hold the fairing in the proper position while the bolts and large washers are installed and tightened securely. The washer goes on the front side over the tab holes to hold the fairing firmly in place.
3. Repeat the same process on the opposite side.

Note: For an installation video, visit our website and search for the following link: https://youtube.com/watch?v=532U_1Zd3EI (the video shows a stainless model, but the installation is the same).

Optional Polished Stainless Steel Trim Rings

This optional trim ring fits around the light fixture. Prep and paint your fairings first. Once finished, you may install the trim ring if desired.

Installation Instructions

1. Clean the area with rubbing alcohol to remove all oils, including fingerprints.
2. After cleaning, place a piece of masking tape on the mounting area. If it sticks properly, proceed to step 3. If not, repeat step 1.
3. Take the stainless steel trim ring (without removing the backing liner) and place it where it will be mounted to check the fit.
   The wide side of the trim ring faces the outside of the fairing.
   Slightly shape the trim ring to match the fairing’s curves by gently bending it with your fingers.
   Test-fit until it naturally follows the curves without forcing it.
4. Once shaped correctly, remove the backing liner to expose the adhesive. Carefully set the trim ring in place.
   Check alignment and make any final adjustments.
   Press firmly along the entire ring to secure it to the painted surface.
5. Remove the protective plastic film from the top of the trim ring.
6. Repeat the same process for the opposite side.