Page 1,   2


 13721 Spring Hill Dr., Spring Hill,  FL 34611 
Phone: 352 688 8160 M-F EST

PROWLER DASH TRIM KIT - 4 pc set©
PART#  IH-PRDK902
INSTALLATION INSTRUCTIONS

Parts:  2- Instrument Panel Side Trim Pieces, 1- Oval Instrument Panel NARROW Edge Trim Pieces,
1- Music/Environmental Control Panel Trim Piece, 2 - Pens of Adhesive Promoter 

Please Note: Interior vinyl surfaces that have been treated with any kind of silicone treatment such as Armor-All or Vinyl Brite will make it so the moldings will not stick well.  Thoroughly clean the area where the molding will be mounted with a cleaner such as ISOPROPYL ALCOHOL (Found at Walmart or your local hardware store).   

 

  1. IMPORTANT:  Clean door panel, Dash area, Door Speaker areas where you are going to mount the moldings with household rubbing alcohol and ISOPROPYL ALCOHOL then wipe off any and all residues.  Then wipe until dry.

 

  1. Start with the “Dash Oval Instrument Panel” piece first.  It is the most narrow of the trim pieces. Take the piece and hold it up to the oval instrument panel. 
    Do not take the red backing off the molding yet.     
    You might even want to tape it down in a few places just to get an idea of how it fits.  It is supposed to be slightly too long so that you can cut it to the exact size once it is mounted (use scissors).  Once you feel comfortable with how it will fit remove the molding and re-insure that the area it is be mounted is clean.
     
  2. Carefully wipe the exact area where the molding will be mounted with the Adhesive Promoter packet provided. This helps the molding to form a permanent bond.  Keep the molding as close to the edge of the instrument panel as possible.
    Note:  Only wipe the area right before you are ready to mount the molding.
     
Put the end of the molding at the center of the bottom painted oval instrument panel and hold it there. (This is where your seam will end up.)  While holding this down carefully work the molding along the edge of the Dash sticking it down as you go.  Pull the Red back side of the molding off as needed, as you go. 
Press the molding firmly as you go. 
Once you reach the sharp bend at the side of the instrument panel hold the molding down tightly at the edge of this curve.  Then bend the molding sharply.  Holding it down tightly as you mount it around the bend.  Once you reach the seam allow the two ends (the mounted where you first started) to overlap.  Measure the excess (the overlap) and Trim off the excess molding with a pair of scissors.  The fit should be very tight.   Note:  It is better to end up a little long and trim it again than too short.  If you end up too short, then you can hold the molding down and stretch it until the ends meet tightly at the seam.

Page 1 of 2