Page 1,   2
 

Page 2 of 2      PROWLER DASH TRIM KIT  Instructions
 

  1. Now take the two (2) pieces that run horizontal on either side of the dash.  Start the firs piece (either side) at the curved edge of the Oval Instrument Panel.  Hold the end of the molding there tightly.  With both hands carefully mount the molding along the line in the dash panel out until you reach the end of the dash panel.  Remove the Red backing as you did with the Instrument Panel. 
    Once at the end you will hold the molding tightly in place and sharply end it to go around the corner.  Continue to the run the molding as far as possible where the end is hidden by the door weather stripping.
    Now do the other side the same way.

     
  2. The last piece to mount is the lower instrument panel where your stereo controls are.  Work it the same way you did the Upper Oval Instrument Panel.  Ensure the seam ends up at the bottom.

    If any questions occur during installation please contact us at:
    admin@TheProwlerStore.com
     

 

CARE AND MAINTENANCE:

Note: Care must be taken when cleaning your trim. It is a good idea to lightly dust your trim with a clean soft.  Then wipe (using a new clean soft cloth) with a good quality streak free glass cleaner.
You may now use Armor-All and other similar products on your interior surfaces.
 
 


TheProwlerStore.com is a Hot Car Accessories, Inc. site

Copyright 2005 - 2024
Not affiliated with Chrysler Corporation or it's divisions.