(This has opened into a new window on your computer)
Instructional Photographs
Previous Page - Page 2 - Next Page
Picture 11
Press on the A-Arm cover to ensure it is seated on the surface of the original A-Arm.
Picture 12
Pull the A-Arm cover towards the wheel as far as it will go.
Picture 13
Should fit as shown.
Picture 14
Retrieve you tube of silicone included in your kit.
Picture 15
Cut tip off the tube on an angle as shown.
Picture 16
You will be siliconing along the under side seem where the
A-Arm cover meets the cars A-Arm.
Picture 17
Silicone the seems of both sides.
Picture 18
As shown...
Picture 19
Use your finger to wipe smoothly in place along the seems.
Picture 20
Final position of lower D.S. A-Arm cover.
Previous Page - Page 2 - Next Page
TheProwlerStore.com is a Hot Car Accessories, Inc. site
Copyright 2005 - 2024
Not affiliated with
Chrysler Corporation
or it's divisions.
