(This has opened into a new window on your computer)
6pc
Front Control Arm Set©
PART #
ACC-822025
Instructional Photographs
To Page 6
- Page 1 -
Next Page
Picture 1
Before we start - Factory A-Arm assembly.
Picture 2
Masking tape the body of car near the A-Arm to protect from scratching.
Picture 3
Masking tape the wheel fender to protect from any scratching.
Picture 4
Start with "Lower Drivers side A-Arm cover".
Picture 5
Slide the end cut out notch under the bolt as shown.
Picture 6
Begin to slide toward back of car.
Picture 7
Sliding...
Picture 8
Slide as far as it will go.
Picture 9
Here is the trickiest part of the whole assembly. Press the body
wall back in towards the car firmly as far as it will possibly go
and hold. You may want someone else to do this while you
position the A-Arm cover. Slide A-Arm cover over until it goes
inside the A-Arm cut out on the fender.
It is a tight fit but it will go in.
Picture 10
Continue to slide the A-Arm cover back and over the original
A-Arm.
NOTE: The A-Arm covers are not designed to fit snuggly against
your original A-Arms. There will be a gap as much as 3/8's of an
inch. This will not effect the appearance or security of the A-Arm cover.
It will stay firmly in place once silicone is applied.
TheProwlerStore.com is a Hot Car Accessories, Inc. site
Copyright 2005 - 2024
Not affiliated with
Chrysler Corporation
or it's divisions.
