INSTALLATION INSTRUCTIONS

Parts: 2 Door Panel Large Trim Pieces, 2 Speaker Edge Small Trim Pieces, 2 Promoter Pens

Please Note: Interior vinyl surfaces treated with silicone products such as Armor-All or Vinyl Brite may prevent the molding from sticking properly. Thoroughly clean these areas with isopropyl alcohol (available at Walmart or any hardware store) before installation.

1. IMPORTANT: Thoroughly clean the door panel and door speaker areas where you will mount the moldings with household rubbing alcohol and isopropyl alcohol. Wipe off any residue completely.
2. Start with the speaker circle perimeter. Carefully wipe the exact area where the molding will be mounted using the adhesive promoter packet provided. Pay close attention to the indent surrounding the inset area. Only wipe the area immediately before mounting the molding.
3. Position the end of the molding at the bottom center of the speaker (so the seam is at the bottom when finished) and hold it in place, pressing down for one full minute. While holding the molding, carefully work it around the perimeter of the round door speaker, peeling the red backing off as you press the molding down. Move both hands along the molding around the speaker, pressing firmly as you go.
4. Once you have gone all the way around and returned to the starting point, pause. There will likely be extra trim molding. Trim it so the end meets the beginning for a tight fit. Gently lay the end down, mark where to cut, and use scissors to trim the molding while it is still mounted. Lay the trimmed end down to meet the beginning.
5. Repeat this process for each door panel and door speaker.
   Remember: It is better to cut the molding slightly too long than too short. You can always trim it again if it is too long. If the cut is slightly short, you can stretch the molding slightly to make it fit.