INSTALLATION INSTRUCTIONS

Parts included: 2 x Door Panel Large Trim Pieces, 2 x Speaker Edge Small Trim Pieces, 2 x Promoter Pens.

Please note: Interior vinyl surfaces treated with silicone products such as Armor-All or Vinyl Brite can prevent molding from sticking properly. Clean these surfaces thoroughly with isopropyl alcohol before installation (available at Walmart or any hardware store).

1. IMPORTANT: Thoroughly clean the door panel and door speaker areas where the moldings will be mounted using household rubbing alcohol and isopropyl alcohol. Wipe off any residues.
2. Start with the speaker circle perimeter. Carefully wipe the exact area where the molding will be mounted with the adhesive promoter packet provided. Pay close attention to the indent surrounding the inset area. Only wipe the area immediately before mounting the molding.
3. Place the end of the molding at the bottom center (so the seam is at the bottom when finished) and press down for one full minute. While holding the molding, carefully work it around the perimeter of the round door speaker, peeling the red backing off as you go. Move both hands around the speaker, pressing firmly as you proceed.
4. Once you have gone around the entire perimeter and met the starting point, pause. You will have excess molding. Trim it so that the end meets the beginning with a tight fit. Mark the trim location with a pen while the molding is mounted, then use scissors to cut and lay the end down to meet the beginning.
5. Repeat the process for each door panel and door speaker. Remember: It is better to cut the molding slightly too long than too short—you can always trim it again. If the cut is slightly too short, you can stretch the molding slightly to make up the difference.