13721 Spring Hill Dr., Spring Hill,  FL 34611 
Phone: 352 688 8160 M-F EST 

Prowler Universal Emblem/Sticker application.
Universal directions for applying stick on vinyl emblems.
INSTRUCTIONS
 

Parts included:     emblem(s), promoter pen or packet

WARNING:  It is very important to follow every step without skipping anything. This will ensure that you mount your emblem permanently.

Applying your new Logos:

1.  First, wash the area where your current logos to be replaced are with soap and water. .
Le dry for a couple of minutes.
 

2.  IMPORTANT:  Next scrub with rubbing alcohol thoroughly to remove any invisible oils.
NOTE:  If you have used a protectant such as wax or Armor-All you will have to go through a more thorough cleaning process.  Use a solvent such as thinner inside the indented letters to remove. 
 

3.  Now take the packet or small pen of 'promoter' provided.  Apply the clear moist promoter appliqué to the exact area you are going to mount your emblem(s).
The promoter will not hurt your cars paint.  Any excess can be wiped away with rubbing alcohol.
The foil packet has a moistened sponge inside.  If you get the "pen" applier bend the pen so the class ampoule inside breaks.  Then push the spongy tip against a clean piece of paper to get the liquid to flow.  Now you are ready apply it to your surface.

IF you have to remove an existing emblem continue.  If you do not skip to step .6

4.  Take the pink scrapper included in your kit and gently pry and push off existing emblem(s) of your stock emblem that is currently on your car.
 

5.  Once you have removed the emblem you should have slight residue outlines where each letter was.  This will help you gage where to place your new logos.

6.  It is time now to install your new emblems.  First hold the emblem up to where you are going to mount it to and see where you want to mount it.
Whoever mounts these new logos should have a good eye for mounting them straight (that is perpendicular to the ground).
 

7.  either use the piece of test tape we provided (even a piece of regular masking tape will work) and try sticking it to the surface you cleaned in several places.
If it sticks continue the step 8.  If not re-clean until it sticks.
 

8.  Take one of your new emblems and gently peel the white stiff paper backing off (Diagram A).  You will be left with the logo stuck to the clearish top liner.

Hold the emblem up to where you would like to mount it – at first without touching your car to get comfortable of where it will be placed.
Once you are certain where you want to mount the logo slightly touch the logo to the cars surface.  Make any last tiny movements.
Once you are satisfied press down on the entire surface of the logo. Then press firmly along the top of the entire surface to ensure a tight bond.

Now very gently pull off the top clear liner, see Diagram B.

Now wipe down the letters and the car surface around them.  Any residue left over from the original logos can be removed with rubbing alcohol.
 

    
Diagram A                                                                                                    Diagram B 
                                                                                                                         Once the emblem is on your cars surface peel off the top liner.

TheProwlerStore.com is a Hot Car Accessories, Inc. site

Copyright 2005 - 2024
Not affiliated with Chrysler Corporation or it's divisions.