Phone: 352 688 8160 M-F EST

PROWLER Side Marker Light Wings Bezel©

PART#  ACC-822013

INSTALLATION INSTRUCTIONS

      Parts included Base on a two set or a four set:                                                        

       2 x Polished Trim Wing Bezels,  1 x Adhesive Promoter packet

1. Clean existing areas around the side marker light first with soap and water to remove any dirt then again with household Isopropyl Alcohol or Rubbing Alcohol.  Let dry.
    
2. Without removing the backing from your new parts - Take your Light Trim Bezels one at a time, and hold them up to each Side Marker Light.  Line them up with the light lens.  Ensure the wings are straight out in line with the ground.  Position them so that you feel comfortable with how they are going to mount.   
    
3. Take the packet or pen of promoter and open it up.  Dampen the area around the light lens where the trim bezel will attach.  This will help the tape stick firmly.
    
4. Once you are comfortable with the fit - peel the back off your first Light Trim Wing Bezel.  Position it slight over the top of the first light lens without touching it to the light.  Carefully set the trim bezel on top of the light like you did during your practice run.
   
   NOTE:  It is difficult to move the Trim Bezel once you attach it to the area around your light lens.  Be sure to position it correctly the first time you install it.
    
   NOTE:  Each Light Trim Wing Bezel is designed for its side of the car.  They will each be positioned so that the wings are pointing to the rear of the car. 
    
5. Once you have mounted the Light Trim Wing Bezel press it firmly along the entire area from top to bottom and them from Left to Right.  Repeat the process for the other side Wing Bezel.  Let set over night.
    

Clean using a clean cloth and good quality glass cleaner.

TheProwlerStore.com is a Hot Car Accessories, Inc. site

Copyright 2005 - 2024
Not affiliated with Chrysler Corporation or it's divisions.