Phone: 352 688 8160 M-F EST

PROWLER High Polished Stainless Steel Spindle Caps©

PART #  ACC-822023

INSTALLATION INSTRUCTIONS

Parts Included:  2 x  Spindle Caps,   6 x stainless steel nuts,  6 x washers (optional)

Your new stainless covers come to you with a protective liner. Do not remove liner until installation is complete.

1. Your new covers are designed to fit over the three upper spindle bolts WITHOUT having to remove the factory nuts. So, do not take the factory nuts off the bolt studs - leave them mounted.  Now, simply place the new cover over the factory bolts then place two of the stainless steel washers (provided) over the two bolts that are located side by side first...then fasten with two of the acorn nuts (provided). TIGHTEN LOOSELY.
   NOTE:  (some factory bolt studs are shorter than the others.  It is possible that you may one or more studs too short to add the washers, in this case just leave the washers off)
    
2. Using a small flat head screw driver insert the driver into the hole to pull the cover tab over the remaining bolt stud.  IT WILL BE A TIGHT FIT.  A tight fit eliminates any potential rattles. 
    
3. Ensure the Spindle Cap Cover is push back toward the wheel as far as it can go.  Place the one remaining acorn nut over the single bolt stud and tighten. This nut does not need a washer.
    
4. Tighten the first to bolts on the other side of the Spindle Cap.    Remove the clear protective liner.
    
5. Repeat steps 1-4 for opposite side.

If any questions occur during installation please contact Admin@TheProwlerStore.com

CARE AND MAINTENANCE:

Note: Care must be taken when cleaning your covers. It is a good idea to lightly dust your covers with a clean soft cloth first in order to prevent any particles from scratching them.
Then wipe (using a new clean soft cloth) with a good quality streak free glass cleaner.

TheProwlerStore.com is a Hot Car Accessories, Inc. site

Copyright 2005 - 2024
Not affiliated with Chrysler Corporation or it's divisions.