13721 Spring Hill Dr., Spring Hill,  FL 34611 
Phone: 352 688 8160 M-F EST

Stainless Steel Prowler Steering Wheel Control Trim 2pc©

PART#  ACC-PRID909F

INSTALLATION INSTRUCTIONS
(Please Read before beginning)

Parts included 14 Pieces:
2 X Steering wheel control trim pieces, packet of promoter, and interior test kit. 

IMPORTANT!  Before you begin you must first prepare your steering wheel areas where pieces are going to be installed in order to allow a proper adhesion.
You can do this by scrubbing the entire area first with household isopropyl alcohol. (Found at any hardware department)  You can also use rough  to slightly rough the surface for a permanent bond.

NOTE:  If these areas have been treated with Armor-all or any such surface protector; installation will NOT work unless these treatments have first been removed using special chemicals. 
 

PLEASE NOTE: Once parts are mounted they can not be returned due to installation errors.

1.  To start take each trim piece and hold it up to where you would like it  mounted.  Now push each end (top and bottom) to form it to the steering wheel.  Adjust bend as needed.
Once you feel comfortable with how the trim pieces fit set them aside.

Once your areas have been prepared use the adhesive promoter packs/tubes (provided) to wipe the areas of your steering wheel that will be covered with your new stainless pieces.
Allow a few seconds to dry. You have been provided with attachment to test the tack. If it seams to stick well then you can proceed with your installation.
If you can not get the test tape to stick please refer back to the special preparation instruction sheet and repeat those procedures.  

2.  Before you remove the liner for permanent attachment place each piece into position and check the fit and also get acquainted with just how each part sets in place. It will be necessary to form a few of the parts by hand to conform to the shape of your dash to insure a nice perfect fit without forcing the shape. Once you are satisfied with the shape and fit peel the red release liner and firmly press each piece into position.  

If any questions occur during installation please contact admin@TheProwlerStore.com

Note: EXTRA CARE must be taken when cleaning your dash kit. It is a good idea to lightly dust your kit with a clean soft cloth first in order to prevent any particles from scratching it. Then wipe (using a new clean soft cloth) with a good quality streak free glass cleaner.

TheProwlerStore.com is a Hot Car Accessories, Inc. site

Copyright 2005 - 2024
Not affiliated with Chrysler Corporation or it's divisions.