13721 Spring Hill Dr., Spring Hill, FL 34611
688 8160 M-F EST
PROWLER Gas Cap Cover©
Gas Cap, 1 x Adhesive Promoter Packet
Clean gas cap
area first with soap and water to remove any dirt then with
household Isopropyl Alcohol. Let dry.
Take your new
Gas Cap Cover and place it on top of your Prowlers existing gas
cap. Move it around until it is in a position where it covers the
existing gas cap completely. Open your cars gas cap while holding
your new Gas Cap Cover on top to be sure that your new Gas Cap Cover
is clear of hitting any area on your car. The idea here is for you
to become familiar with its proper placement.
Notice that your stock plastic gas cap has a slight curve in it from
top to bottom. You will want to slightly bend your new metal
gas cap to approximately match this curve. You do this by
placing both of your hands on the new gas cap. With your
thumbs on the back and the rest of your 8 fingers on the front side
lined along the center (long ways).
Place the cap on your leg for support and just slight bend it along
this center line.
Once you attach the Gas Cap Cover
you will not be able to move it again.
Once you are
satisfied with the fit remove the red liner from the attachment tape
on the underside of the as Cap Cover. Very carefully hold the Cover
over your cars gas cap. When you are certain it is in the correct
position - Press firmly to set. Push firmly along the entire
perimeter edge to ensure a tight bond. It is best to let it set for
8 hours. Do not get it wet during this time.
Care must be taken
when cleaning your cover. It is a good idea to lightly dust your cover
with a clean soft cloth first in order to prevent any particles from
scratching it. Then wipe (using a new clean soft cloth) with a good
quality streak free glass cleaner.
TheProwlerStore.com is a Hot Car Accessories, Inc. site
Copyright 2005 - 2019
Not affiliated with
or it's divisions.