Phone: 352 688 8160 M-F EST

PROWLER Headlight Lens Protectors

PART#  ACC-822001  or  ACC-822002
INSTALLATION INSTRUCTIONS

Parts included:    

2 x Headlight lens film guards, 1 x Small felt squeegee

For installation you will need: Household Rubbing Alcohol, a soapy water mixture of one full spray bottle of water and a couple of drops of baby shampoo or mild dish detergent.

WARNING:  It is very important to follow every step without skipping anything. This will ensure that you mount your lens guards professionally.

1.  Prepare both headlight lens by first washing with soap and water to remove dirt and grime. Dry completely and scrub the lens with household Rubbing Alcohol.

2.  Place your unpeeled headlight guard over your headlight and make note of its fit. You now have an idea of how it sits on the plastic Headlight lens so remove the guard and spray your mixture of soapy water directly on the headlight lens and on your new headlight guard soaking it down as you peel the release liner. 
Once both the headlight lens and the lens guard are completely saturated place the guard on the lens and position it into place.

3.  You have been provided with a soft rubber tipped type squeegee. Starting at the center of the light lens, use the squeegee to work the fluid out in all directions until the lens guard has become completely adhered. A household hair dryer may help if some areas become stubborn for any reason.

4.  Repeat the entire process for the opposite side.

5.  Repeat the entire process for the Fog Lights as well.

TheProwlerStore.com is a Hot Car Accessories, Inc. site

Copyright 2005 - 2024
Not affiliated with Chrysler Corporation or it's divisions.