Phone: 352 688 8160 M-F EST

Prowler Fender Vinyl Marker 3-D Raised Emblem Set of 2

PART#  GC-CS-SideMark   

INSTALLATION INSTRUCTIONS

Included:  2 x Vinyl Oval Side Marker Covers, 1 x promoter packet  

 
1.  Wash you’re Side Marker Lights on your fenders with Rubbing Alcohol.  This will remove all the oil on the surface. Be sure to clean every nook and cranny around the area so that your Trim Plate can get a good adhesive grip.

2.  Take Vinyl Oval Side Marker Cover and put it up to you’re Side marker light on your fender. Center the Cover in the center of the Marker light.  You will see a little bit of Marker light around the exterior of the Cover.  Position it as you want to permanently mount it. 
Once you are comfortable with exactly how it will fit you may take the red backing off the back side exposing the sticky tape.

3.  Take your promoter packet and wipe the entire area where your Vinyl Oval Side Marker Covers are going to attach.
 

4.  Very carefully re-position the Vinyl Oval Side Marker Covers in place without touching it against the Side marker light.  Once you are certain that is where you want it - lightly set it against the marker side light. Make any final tiny adjustments.  Once this is done, press on the Trim Oval Cover firmly.  With your fingers press all around the surface of the Vinyl Oval Side Marker Cover to ensure it is sticking everywhere it touches the dash.

5.  Do the same to procedure to the other side.  Clean the area with rubbing alcohol.