P.O. Box 6259, Spring Hill, FL 34611 
Fax:  352 666 4141

Chrysler Wings Emblem

PART#  JU-4805988AB or JU-0480-6083AB

INSTALLATION INSTRUCTIONS

The Chrysler “Wings” Emblem that you have purchased is either a new OEM (Original Equipment Manufacturer) part.

All Prowlers were Chrysler products and therefore can proudly where the Chrysler wings emblem.  Prowler years 2001 – 2002 were produced directly under the Chrysler name.  Although years 1996 – 2000 were produced under the Plymouth name, Plymouth is a Division Chrysler.

 

Each wing emblem has automotive professional grade double stick tape for your convenience. 

1. Take the emblem without removing the red backing from the tape and hold it on the back trunk of your Prowler.  Move it around in different positions until it looks the best to you.  There is no right answer here since the emblem was not included from the factory on the Prowler.

2.  Once you have identified the spot you will need to take a china marker or some soft chalk and mark its position.  If you want it centered on your trunk over the license plate you will have to measure the width of the cars back end.  Divide the number in half and mark the center.

3.  Clean thoroughly the area where you plan to mount the emblem then dry completely.

4.  Carefully peel the red backing off the back of the emblem.

Warning:  This is a permanent stick tape. You will not be able to take it off without damaging your cars paint and the emblem itself. 
Hold the emblem over the spot where you want to place it. Be sure it is perfectly lined up.  Press down gently at first – you might be able to move it ever so slightly if you need to. Now press firmly all over the emblem and let sit for 4 – 6 hours to bond.

TheProwlerStore.com is a Hot Car Accessories, Inc. site

Copyright 2005 - 2024
Not affiliated with Chrysler Corporation or it's divisions.