13721 Spring Hill Dr., Spring Hill,  FL 34611 
Phone: 352 688 8160 M-F EST 

Prowler Deluxe Stainless Steel Mirror Polished Front Mud Guards (Set of 2)©

PART#  ACC-822038 Polished 

INSTALLATION INSTRUCTIONS

Parts included: 

2  x  Stainless Steel Front Mud Flaps;                   6  x  1/4 Stainless Flat Washers:

6  x  3/4" long 1/4" 20 stainless steel Mounting Carriage Bolts;       6  x  1/2" 1/420 Stainless Lock Nuts

1.   Although it is not absolutely necessary to remove the front wheels for this installation it will make this installation much easier. If you elect to remove the front wheels jack the front of your prowler up off the ground and place it on jack stands for safety and then remove both front wheels.

2.  You will notice three slotted perches attached to the inside of each wheel fender. Slide the stainless carriage bolts down into these slots.
TECH TIP:  Sometimes the carriage bolt can sit a little lose in these slots and make tightening of the bolts a little difficult. If this should happen apply a couple of drops of five minute epoxy between the head of the bolt and fender and allow it to dry. Then proceed to set the mud guard over the bolts and center its position.

3.  Starting with the center bolt apply the stainless flat washer and lock nut and tighten securely. Once the center bolt is fastened make sure that the mud guard is nice and centered onto the fender and then apply the last two washers and lock nuts. Replace the wheel.

 Note: Care must be taken when cleaning your cover. It is a good idea to lightly dust your cover with a clean soft cloth first in order to prevent
 any particles from scratching it. Then wipe (using a new clean soft cloth) with a good quality streak free glass cleaner.

 
  Questions?  Please contact:  admin@TheProwlerStore.com

 
©