13721 Spring Hill Dr., Spring Hill,  FL 34611 
Phone: 352 688 8160 M-F EST

 

PROWLER Stainless Steel Deluxe Interior Trim Pieces©

PART#  ACC-821031  or  ACC-821017 A,B,C,D,E,G,H,J (Brushed)  or  ACC-821017 A,B,C,D,E,G,H,J  (Polished)

INSTALLATION INSTRUCTIONS

Included:  Trim Part(s), 1 x Promoter Packet, 1 x Tape Test Kit

  

IMPORTANT!  Before you begin you must first prepare your dash/door areas where the pieces are to be mounted in order to allow a good adhesion.
You can do this by scrubbing the entire area first with household isopropyl alcohol (found at any grocery store or hardware store).
 
NOTE: If these areas have been treated with Armor-all or any such surface protector; installation will NOT work unless these treatments have first been removed using special chemicals.  Use a rough pad to slightly rough up the surface if you have trouble after cleaning in making the part stick.
We can not be responsible for kits not sticking do to improperly prepared surfaces.

 

PLEASE NOTE: Once parts are mounted they can not be returned due to installation errors.

 

 1.  Once your areas have been prepared use the adhesive promoter packs/tubes (provided) to wipe the areas of your dash/door that will be covered with your new stainless pieces.
Allow a few seconds to dry. You have been provided with attachment
to test the tack.  Peel the back off a test tack strip and stick it to the area on interior (then remove it). 
If it seams to stick well then you can proceed with your installation.
If you can not get the test tape to stick please refer back to the special preparation instruction sheet and repeat those procedures.
  

2.  Before you remove the liner for permanent attachment - place each piece into position and check the fit and also get acquainted with just how each part sets in place. It will be necessary to form a few of the parts by hand to conform to the shape of your dash to insure a nice perfect fit without forcing the shape. Once you are satisfied with the shape and fit peel the red rear liner and firmly press each piece into position.  Press it down firmly along the entire surface of the trim piece.

If any questions occur during installation please contact office@TheProwlerStore.com

 

Note: EXTRA CARE must be taken when cleaning your dash kit. It is a good idea to lightly dust your kit with a clean soft cloth first in order to prevent any particles from scratching it. Then wipe (using a new clean soft cloth) with a good quality streak free glass cleaner.

 

      
       

 

 

TheProwlerStore.com is a Hot Car Accessories, Inc. site

Copyright 2005 - 2024
Not affiliated with Chrysler Corporation or it's divisions.