Phone: 352 688 8160 M-F EST 

Prowler High Polished Stainless Steel Fender Caps 2-pc©

PART#  ACC-823014   

INSTALLATION INSTRUCTIONS

Included:  2 x Stainless steel Fender Caps, 6 x chrome resin caps  

NOTE:  Your new covers come to you with a protective liner.  Do not remove liner until prompted by instructions.

                                                                                               
1.  Wash thoroughly the tops of fenders in your engine compartment where you will be mounting your Fender Cap Trims.   Let Dry.   Wipe down area with rubbing alcohol to remove any trace of oil.  Let dry.
 

2.  Remove the three fender bolts on top each side of your engine compartment.

3.  Place the corresponding fender trim cap in position over the bolt holes. Once that you are familiar with how these trim caps fit go to the next step.

4.  Remove protective liner then replace the stock fender bolts.

5.  You have been provided with six decorative chrome bolt covers. To install these covers simply apply a small dab of clear 100% silicone adhesive to the under side of each cap and place over the bolt head allow a few hours to set. Be careful not to apply to much silicone as this will tend to ooze out the sides creating a mess.  

 
 CARE AND MAINTENANCE:

Note: Care must be taken when cleaning your cover. It is a good idea to lightly dust your cover with a clean soft cloth first in order to prevent any particles from scratching it. Then wipe (using a new clean soft cloth) with a good quality streak free glass cleaner.

Questions?  Please contact:  admin@TheProwlerStore.com

TheProwlerStore.com is a Hot Car Accessories, Inc. site

Copyright 2005 - 2024
Not affiliated with Chrysler Corporation or it's divisions.